2 | #56037 Valve Kit & #40547 Hose Kit Cont’d | |||
Install Fittings to Tractor Hydraulic Line |
|
| ||
Refer to Figure 17 and Figure 18. |
|
| ||
| ||||
1. | If not done during installation of right rear loader |
|
| |
mount, remove the tractor hydraulic line connector |
| /,1( | ||
tube or adapter block (if equipped) as shown in Figure |
| 6833257 | ||
2. |
|
| %5$&.(7 | |
NOTE: If |
|
| ||
sleeve, discard them. |
|
| ||
2. | Connect adapters (2) to each |
|
| |
(4) and tighten. NOTE: Use sealant on pipe threads. | 72 /2$'(5 | )520 /2$'(5 9$/9( | ||
3. | Attach adapters (2) to PBY and IN hoses. Tighten | |||
9$/9( ,1 3257 | 3%< 3257 | |||
finger tight. | (1*,1( (1' | 75$160,66,21 (1' |
4.Route IN hose inside the right loader mount. Install elbow onto end of tractor hydraulic line as shown in Figure 18.
5.Route PBY hose inside right loader mount. Remove plastic cap and install onto transmission end of tractor hydraulic line as shown in Figure 18.
6.Point elbows up and slightly out to clear the hydraulic Return line as shown.
7.Tighten elbows to tractor line and tighten hoses to adapters.
Figure 18 Hose Hanger Bracket Installed
2.315038 1/2 NPTF x 3/4 JICM Adapter
4.40549 1/2 NPTM x M26 x 1.5M 90° Elbow
7.360130 54” Hose
11.480261 Clamp
12.6128 1/4 NC Lock nut
13.300057 1/4 NC x 3/4 Cap screw