2
#56037 Valve Kit & #40547 Hose Kit Cont’d
Assemble Control Valve Kit
1.Install the control lever:
a)Thread end of handle (9) into valve.
b)Align handle so that end with longer bend is pointing toward the adapter fittings. Make sure bends are in line with front and rear of valve.
c)Tighten jam nut (38) already installed on han- dle.
d)Slide boot down over boot bracket.
2.The valve mounting plate contains two sets of holes. Select the holes that will position the valve in the desired location. Install the valve mounting plate
(8) to the right loader mount, using two 5/8 NC x
3.Install 3/8 NC x
Carriage bolts must be installed so that the head is inside the loader mount.
4.Attach the valve mount to the valve plate so that the control valve will be in the correct position for operation. Secure with three 1/2 NC x
5.Control valve must be positioned so that move- ment of tractor controls is not restricted. Maintain at least 6” spacing between control valve kit and any tractor control (brake pedals, accelerator, hand throt- tle, or hydraulic levers.) Check for clearances in the operating position.
6.Torque all hardware to specifications given below.
TORQUE SPECIFICATIONS
| Wrench |
|
Bolt | Size | Required Torque |
3/8 NC x | 9/16” | 35 |
1/2 NC x | 3/4” | 85 |
5/8 NC x | 15/16” | 170 |
9
38
17
35 | 8 |
3334 | |
30 | 32 |
36 | |
40 | 37 |
39
41
4243
CD5733
Figure 17
8.46340 Valve mounting plate
9.56254 Bent handle
17.56095 3/8 x 54” Hose
30.20973 3/8 NC x
32.565 3/8 Flat washer
33.838 3/8 Lock washer
34.835 3/8 NC Hex nut
35.12735 1/2 NC x
36.3598 1/2 Flat washer
37.855 1/2 Lock washer
38.13859 Jam nut
39.1093 1/2 Hex nut
40.5607 5/8 NC x
41.3632 5/8 Flat washer
42.1286 5/8 Lock washer
43.230 5/8 Hex nut