TROUBLE-SHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please contact the establishment where this tread-
mill was purchased | . |
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page
8.) Use only a
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
c. Check the circuit breaker located on the treadmill near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in.
d. Check the on/off switch located on the treadmill near the power cord. The switch must be in the on position.
PROBLEM: The power turns off during use
c |
|
Tripped | Reset |
d | On |
| |
| Position |
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. Make sure that the on/off switch is in the on position.
PROBLEM: The displays of the console do not function properly
SOLUTION: | a. Remove the key from the console and | unplug the power cord. | Remove the screws from the |
| hood and carefully remove the hood. |
|
|
Locate the Reed Switch (21) and the Magnet (43) on the left side of the Pulley (42). Turn the Pulley until the
Magnet is aligned with the Reed Switch. | Make sure |
that the gap between the Magnet and the Reed |
|
Switch is about 3 mm (1/8 in.). | If necessary, loosen |
the Reed Switch Screw (76) and move the Reed |
|
Switch slightly. Retighten the Screw. |
|
hood, and run the treadmill for a few minutes to check for a correct speed reading.
PROBLEM: The pulse display on the console does not function properly
3 mm | 42 | |
76 | ||
| ||
21 | 43 | |
Top |
| |
View |
|
SOLUTION: a. Wash your hands before to using the pulse sensor. In addition, keep the pulse sensor clean using a damp cloth and a small amount of mild detergent.
20
