ASSEMBLY
Assembly requires two people. | Set the treadmill in a cleared area and remove all packing materials. Do not | |
dispose of the packing materials until assembly is completed. | Assembly requires the included allen wrench | |
and your own phillips screwdriver | and wire cutters | . |
Note: The underside of the treadmill walking belt is coated with
1.With the help of a second person, carefully raise the treadmill to the upright position.
Whilst a second person tips the treadmill to one side
and holds it, insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other side | and insert the |
other Extension Leg (not shown) in the same way. L | ower |
the side of the treadmill so that both Extension Legs |
|
(102) are resting flat on the floor. |
|
With the help of a second person, carefully lower the |
|
treadmill frame. |
|
2.Press the Lock Knob Sleeve (70) into the left Upright (69). Make sure that the Lock Pin Collar (72) and the Spring
(71)are on the Lock Pin (74). Insert the Lock Pin (74) into the Lock Knob Sleeve (70) and the left Upright (69). Next, press the Lock Knob Spacer (117) onto the left Upright.
Tighten the Lock Knob (68) onto the Lock Pin.
3. With the help of a second person, carefully tip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each Extension Leg (102) with two Screws (111) as shown.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
Note: One replacement Base Pad (99) may be included. Use the Base Pad to replace any Base Pad that becomes worn.
6
1 |
| Frame |
|
| |
|
| 102 |
|
| 99 |
2 |
|
|
|
| 69 |
68 |
|
|
|
| 70 |
| 117 | 71 |
| 72 | |
|
| |
|
| 74 |
3 |
|
|
| 99 |
|
69 |
| 69 |
| 111 | |
|
| |
| 111 | 102 |
99 |
| |
102 |
| |
|
|
