2.WhileanotherpersonliftstherearoftheFrame(1),
attachtheRearStabilizer(6)totheFramewithfour M8x 44mmButtonScrews(84)anda SupportPlate (104)asshown.
3.Slidea RampCover(48)ontoan M6x 16mmPatch Screw(76)asshownTightenthePatchScrewinto. oneendofthePivotAxle(14),whichisthelongerof thetwoaxlesApplya. smallamountof theincluded greasetothePivotAxle.
HaveasecondpersonholdthetwoRampSpacers (99)againstthesidesoftheFrame(1)sothatthey covertheindicatedtubeson theFrameAlignthe. roundtubesontheRamp(3)withtheRampSpacers.
Make sure that the Ramp is turned as shown in
drawing 4 below. Insert the Pivot Axle (14) into the Ramp, the Ramp Spacers, and the Frame. tf neces- sary, tap the Pivot Axle with a rubber mallet to insert it.
Slide a Ramp Cover (48) onto an M6 x 16mm Patch Screw (76) as shown. Tighten the Patch Screw into the open end of the Pivot Axle (14).
4.Slide an M6 Washer (64) onto an M6 x 16mm Patch Screw (76). Tighten the Patch Screw into one end of
the Incline Axle (13). Apply a small amount of grease to the Incline Axle.
Raise the Ramp (3). Insert the Incline Axle (13) into the welded tube under one side of the Ramp, through the motor screw, and then into the welded tube under the other side of the Ramp. As you insert the Incline
Axle through the motor screw, make sure that the motor screw does not turn.
Slide an M6 Washer (64) onto an M6 x 16mm Patch Screw (76). Tighten the Patch Screw into the open end of the Incline Axle (13).
3\
Grease
48
14
76
Grease
\
13
64
1O4
48
99 Tubes
1
Motor
Screw
6
