![](/images/new-backgrounds/1320006/32000615x1.webp)
7. Identify the Left Pedal (10), which is widest at the rear | 7 |
|
|
|
and has an opening on the left side. Attach the Left |
| 118 |
| |
|
|
| ||
Pedal to the Left Pedal Leg (4) with two M8 x 58mm |
|
|
|
|
Button Screws (83). |
|
|
|
|
Attach the Right Pedal (11) to the Right Pedal Leg (5) |
|
|
|
|
in the same way. |
|
| 5 |
|
Attach two Pedal Wheels (28), an M10 Washer (126), |
|
|
| 11 |
|
|
|
| |
and the Left Upper Body Leg (31) to the Wheel Frame |
|
|
|
|
(30) on the Left Pedal Leg (4) with an M10 x 78mm |
| 31 | 65 | Wide |
Bolt Set (65). Make sure that the Bolt Set, Pedal |
| End | ||
|
| |||
Wheels, Washer, and Upper Body Leg are oriented |
| 126 |
|
|
as shown. |
| 30 |
|
|
Attach the other two Pedal Wheels, the Right Upper | 28 |
| 28 |
|
|
|
|
| |
Body Leg, and an M10 Washer (not shown) to the |
|
|
| 10 |
Wheel Frame (not shown) on the Right Pedal Leg (5) |
| 65 |
| |
in the same way. |
| 4 |
| |
|
|
| 83 | |
8. Have another person hold the Console (17) near the | 8 |
|
|
|
Upright (2). |
|
|
| |
|
| 17 |
| |
|
|
|
| |
| Do not pinch |
| ||
Connect the Upper Wire Harness (115) to the wire har- |
| the wires |
|
|
ness on the Console (17). Connect the Pulse | during this step. |
| ||
|
|
|
| |
Extension Wire (114) to the pulse wire on the Console. |
|
|
|
|
Next, locate the two ground wires that are attached |
|
| 114 |
|
with a screw to the Upright (2). Connect the ground |
|
|
| |
| 98 |
|
| |
wires to the two smallest wires on the Console. |
|
|
| |
Carefully insert all excess wiring up into the Console |
|
|
| 115 |
(17) and down into the Upright (2). Attach the Console |
|
|
| |
|
|
| Ground | |
to the Upright with four M4 x 16mm Screws (98). |
| 98 |
| |
|
| Wires | ||
(Note: The Screws may be shipped in the console |
|
|
|
|
box.) Be careful to avoid pinching the wires. |
|
|
|
|
|
|
|
| 2 |
9. Plug the Power Cord (116) into the Power Socket | 9 |
|
|
|
(117) at the rear of the elliptical exerciser. |
|
|
| |
|
|
|
| |
|
|
| 117 | 116 |
10.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
8