NordicTrack NTE13920 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and pliers	.

As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on pages 28 and 29. The second number refers to the quantity used in assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it is pre-assembled.

M6 Washer	M10 Split	M10 Washer	Spacer (109)–2	M8 Jam Nut	M6 x 16mm Patch
(64)–2	Washer (73)–2			(86)–6	Screw (76)–4
		(126)–2
M8 x 38mm Button		M8 x 58mm Button Screw (83)–4		M8 x 41mm Button
Bolt (105)–2				Bolt (85)–4
M8 x 44mm Button Screw (84)–8			M10 x 78mm Bolt Set (65)–2
M4 x 12mm	M4 x 16mm		M10 x 110mm Button Screw (70)–2
Screw (96)–1	Screw (98)–4

1.Identify the Front Stabilizer (8). While another person lifts the front of the Frame (1) and holds the Pedal Legs (4, 5) in the position shown, attach the Front Stabilizer to the Frame with four M8 x 44mm Button Screws (84) and a Support Plate (104).

While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame in the same way.

1
1	4, 5
	8
104	84
84

5