6.Identify the Right Handlebar (61) and the Right Handlebar Leg (60), which are marked with
"Right" stickers, and orient them as shown.
Make sure that the hexagonal holes are in the indicated location.
Slide the Right Handlebar (61) onto the Right Handlebar Leg (60).
Attach the Right Handlebar (61) with two M8 x
38mm Bolts (96) and two M8 Locknuts (102). Make sure that the Locknuts are in the
hexagonal holes.
Repeat this step for the Left Handlebar (not shown) and the Left Handlebar Leg (not shown).
. Apply a small amount of grease to the Pivot Axle (35) and to a 16mm Wave Washer (54).
Insert the Pivot Axle (35) through the Upright (4) and then center it.
Slide the 16mm Wave Washer (54), an Inner Handlebar Cover (68), and the Right Handlebar Leg (60) onto the right side of the Pivot Axle (35).
Repeat this step for the Left Handlebar Leg (not shown).
Tighten an M8 x 19mm Patch Screw (82) and an M8 x 25mm Washer (98) into each end of the Pivot Axle (35).
6
61
102
Hexagonal
Holes
96
60
7
Grease
68
60
98
8
