7.Identify the Left Handlebar (19), which is marked with an “L.” Insert the Left Handlebar into one of the Handlebar Legs (17). Next, turn the Left
Handlebar and the Handlebar Leg so that the wide side of the pivot tube on the Left Handlebar is above the hexagonal holes in the Handlebar Leg. Attach the Left Handlebar with two M8 x 38mm Button Bolts (58) and two M8 Nylon Locknuts (72). Make sure that the
Nylon Locknuts are inside of the hexagonal holes. Do not tighten the Button Bolts yet.
Assemble the Right Handlebar (20) and the other Handlebar Leg (17) in the same way.
7
1920
Wide side of
pivot tube
58 | 72 | 58 |
| Hexagonal |
|
| Holes |
|
17 |
| 17 |
8. Apply a small amount of grease to the sides of | 8 |
|
|
|
|
two Wave Washers (88) and two Thrust Washers |
|
|
|
| |
|
|
|
|
| |
(66). |
|
|
|
|
|
Slide the Left Handlebar (19) onto the Handlebar |
|
|
|
|
|
Axle (16) as shown. Next, slide a Wave Washer |
|
|
|
|
|
(88) onto the end of the Handlebar Axle. |
|
|
|
| 20 |
|
|
|
|
| |
Slide an M8 Small Washer (18) and an Axle Cap |
|
|
|
|
|
(41) onto an M8 x 19mm Button Screw (56). |
|
| 19 |
|
|
Next, slide a Thrust Washer (66) onto the shoul- |
|
| 66 |
| |
|
| 16 | 56 | ||
der of the Axle Cap. Then, tighten the Button |
|
| |||
|
|
| |||
Screw into the end of the Handlebar Axle (16). |
|
|
|
| 18 |
Make sure that the Thrust Washer remains |
|
| 88 | 88 | 41 |
on the shoulder of the Axle Cap, and that the |
| 66 |
| ||
| 1 |
| |||
Wave Washer (88) remains on the end of the |
|
|
| ||
18 |
|
|
| ||
Handlebar Axle. |
|
|
|
| |
|
|
|
|
| |
|
|
| Grease |
|
|
Assemble the Right Handlebar (20) in the same | 56 |
| 41 |
|
|
|
|
|
| ||
way. Then, tighten both M8 x 19mm Button |
|
|
|
|
|
Screws (56) at the same time. |
|
|
|
|
|
| 9 |
|
|
|
|
