NordicTrack NTEL4255.0 Assembly, Cluded hex keys, assembly requires an adjustable wrench

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the in-

cluded hex keys, assembly requires an adjustable wrench .

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.

M8 Small	M10 Split	Wave Washer	M10 Washer	M8 Washer
Washer (18)–4	Washer (85)–20	(88)–4	(67)–14	(69)–4
M4 x 16mm	M4 x 19mm	M8 x 19mm Button	M8 Nylon	M10 Nylon
Screw (47)–6	Screw (57)–2	Screw (56)–4	Locknut (72)–4	Locknut (70)–2
M8 x 38mm Button		M8 x 55mm Bolt		M10 x 13mm Button
Bolt (58)–4		Set (92)–2		Screw (54)–14
M10 x 25mm Patch		M10 x 65mm Bolt
Screw (48)–4			Set (94)–2
	M10 x 116mm Carriage Bolt (38)–2
	M10 x 123mm Button Screw (87)–2			Thrust Washer
				(66)–4
		5