12. Apply a generous amount of grease to the axle | 12 |
| |
on the Left Upper Body Leg (24) and to the axle |
| ||
24 |
| ||
on the left Crank Arm (55). Then, apply grease |
| 32 | |
to two Large Wave Washers (89). |
| ||
Grease |
| ||
|
| ||
Slide an Upper Body Leg Spacer (9) and a |
| 9 | |
Large Wave Washer (89) onto the Left Upper | 89 | ||
| |||
Body Leg (24). Make sure that the flat side of | 31 |
| |
the Upper Body Leg Spacer is facing out- | 66 |
| |
ward. Slide the other Large Wave Washer (89) |
|
| |
onto the left Crank Arm (55). | 86 |
| |
|
| ||
With the help of another person, work the left | 32 |
| |
|
| ||
Pedal Arm (32) onto the Left Upper Body Leg |
|
| |
(24) and the left Link Arm (30) onto the left |
|
| |
Crank Arm (55) at the same time. |
| 30 | |
|
| ||
Attach the Pedal Arm (32) to the Left Upper |
|
| |
Body Leg (24) with an M8 x 20mm Patch Screw |
|
| |
(86), an Axle Cover (66), and an M8 x 23mm |
|
| |
Washer (31). |
|
| |
Then, attach the Link Arm (30) to the Crank Arm |
|
| |
(55) with an M8 x 20mm Patch Screw (86), a |
|
| |
Large Axle Cover (52), and an M8 x 23mm | 30 | 89 | |
Washer (31). | |||
| |||
Repeat this step for the right Pedal | 31 | ||
| 55 | ||
Arm (32) and the right Link Arm (30). |
| Grease | |
|
| ||
See step 4. Tighten the M8 x 20mm Button | 86 | 52 | |
Screws (85). |
|
| |
13.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11
