NordicTrack NTEL7506.2 user manual To damage the Upper Wire Harness

6. Apply a generous amount of the included grease	6
to the Upper Body Axle (71). Insert the Upper
			65
Body Axle into the Upright (10). Be careful not				31	86
to damage the Upper Wire Harness (65).			Grease
Apply a small amount of grease to a Wave			71
Washer (80). Slide the Wave Washer onto the left		10
end of the Upper Body Axle (71).
		Grease	80	72
Identify the Left Upper Body Leg (24), which is
marked with a sticker, and orient it as shown.		31
Slide the Left Upper Body Leg onto the left side
	86		80
of the Upper Body Axle (71).
Attach the Left Upper Body Leg (24) to the Upper
Body Axle (71) with an M8 x 20mm Patch Screw		24
(86) and an M8 x 23mm Washer (31).
Repeat this step for the Right Upper Body
Leg (72).
7. Attach the Left Upper Body Arm (22) to the Left	7
Upper Body Leg (24) with three M8 x 16mm
					23
Patch Screws (84) and three M8 x 23mm
Washers (31); start all three Patch Screws
and then tighten them.
Attach the Right Upper Body Arm (23) in the		22
same way.
		31
		84	31
			24
	8