2.While another person lifts the Folding Frame (2), attach the Rear Stabilizer (3) to the Folding Frame with two M10 x 93mm Button Screws (82) and two M10 Curved Washers (99). Next, tighten the Center Foot (95) into the Frame (1).
3.Attach the Front Ramp Cover (6) to the Ramp (5) with four M4 x 16mm Screws (116). Slide an M10 x 25mm Washer (87) onto an M10 x 20mm Button Screw (111). Tighten the Button Screw into one end of the Ramp
Axle (72). Apply a small amount of the included grease to the Ramp Axle.
Orient the Ramp (5) as shown. Align the lower end of the Ramp with the welded tube on the Frame (1). Insert the Ramp Axle (72) into the Ramp and the welded tube.
Slide an M10 x 25mm Washer (87) onto an M10 x 20mm Button Screw (111). Tighten the Button Screw into the open end of the Ramp Axle (72).
2 | 1 |
|
| 95 | 3 |
|
| |
| 2 | 99 |
|
| |
| 99 | 82 |
3 | 6 |
|
116 | 5 |
|
|
| 87 | 111 |
111 87 | 72 |
| 1 |
| Grease |
|
6
