114 96
4748

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.

HOW TO LEVEL THE ELLIPTICAL EXERCISER OR ELIMINATE FLEXING IN THE FRAME

If the elliptical exerciser rocks on your floor during use, turn one or both of the Leveling Feet (98) until the rocking motion is eliminated.

 

88

14, 15

1

12

 

95

98

116

 

If the elliptical exerciser flexes in the center during use, turn the Center Foot (95) until the flexing is elimi- nated.

HOW TO ELIMINATE RUBBING OF THE DISCS

See the drawing above. If the Discs (12) rub against the Side Shields (14, 15) during use, make sure that the Center Foot (95) is installed in the Frame (1). If the Center Foot is installed, loosen the two indicated Bolt Sets (88) and the two M4 x 16mm Screws (116) in each side of the elliptical exerciser.

Adjust the position of the Side Shields (14, 15) until the Discs (12) no longer rub against them, and then tighten the Bolt Sets (88) and the M4 x 16mm Screws (116).

HANDGRIP PULSE SENSOR TROUBLESHOOTING If the handgrip pulse sensor does not function proper- ly, see step 5 on page 15.

HOW TO ADJUST THE BELT

If the pedals slip

 

 

while you are

 

 

pedaling, even

 

 

while the resis-

 

 

tance is adjusted

 

 

to the highest

 

 

setting, the belt

 

 

may need to be

13

 

adjusted. To

 

adjust the belt,

 

12

first carefully pry

 

off the left Disc

 

 

Cover (13) using a flat screwdriver. Next, remove the

four screws (not shown) from the center of the left

Disc (12). Gently rotate the Disc Cover and the Disc

away from the elliptical exerciser.

Loosen, but do

not remove, the three 1/4" x 19mm Button Screws (114). Insert the shaft of a screwdriver downward between the Idler (47) and the Idler Pulley (48).

Pull the top of the screwdriver

toward the rear of the elliptical exerciser until the Belt (96) is tight, and then tighten the three Button Screws. Reattach the left disc with the four screws and then reattach the left disc cover.

22

Page 22
Image 22
NordicTrack NTEL7906.1 Maintenance and Troubleshooting, HOW to Eliminate Rubbing of the Discs, HOW to Adjust the Belt