5.The Console (87) requires four 1,5 V (“D”) batteries (included). Alkaline batteries are recommended. To install batteries, turn the Console face down and remove the Battery Cover (84), as shown in the inset drawing. Insert four batteries into the Console. Make sure that the negative ends of the batteries (marked
Connect the console wire harness to the Extension Wire Harness (51).
Attach the Console (87) to the Upright (2) with the four Console Screws (35) and the four Console Washers
(93)packaged with the Console. Be careful to avoid pinching the wires.
Snap the bookrack onto the Console (87) in the indi- cated location.
6.Remove the four M10 Nylon Locknuts (26) from the welded bolts on the front of the Frame (1).
Whilst a second person holds the Upright (2) near the Frame (1), connect the Extension Wire Harness (51) to the Wire Harness (85).
Align the four holes in the bracket at the bottom of the Upright (2) with the welded bolts on the Frame (1). Lower the Upright, feeding all slack Extension Wire
Harness (51) and Wire Harness (85) into the Upright, until the welded bolts are inserted into the bracket. Do not allow the Wire Harnesses to be pinched.
Lift the front of the Incline Frame (5). Tighten the four M10 Nylon Locknuts (26) onto the welded bolts on the Frame (1).
7.Identify the Left Pedal (41). Attach the Left Pedal to the Left Spring Arm (3) with an M10 x 33mm Carriage Bolt (61), an M10 Washer (63), and an Adjustment Knob (77) as shown. Note: The Left Pedal can be attached in any of five positions (see HOW TO ADJUST THE PEDALS on page 11).
Attach the Right Pedal (not shown) in the same way. Make sure that both Pedals are in the same position.
5 |
| 87 |
|
|
|
|
|
|
|
| |
| 84 |
|
|
| Bookrack |
| Wire |
|
|
| Make sure the |
Harness |
|
| Wire Harnesses | ||
|
|
|
|
| do not get |
| 51 |
|
|
| pinched and |
|
|
| 2 |
| damaged during |
|
|
|
| this step. | |
| 93 |
|
|
| |
|
|
|
|
| |
|
|
|
| 84 |
|
|
|
|
| 87 |
|
| 35 | 35 |
|
|
|
|
|
|
|
| |
6 |
|
|
|
|
|
| Make sure the |
|
|
| |
| Wire Harnesses |
| 2 |
| |
| (51, 85) do not |
|
| ||
| get pinched and |
|
|
| |
| damaged during |
|
|
| |
| this step. | 26 | 26 | ||
|
|
| |||
|
|
|
|
| |
|
|
|
|
| 51 |
|
|
|
| 85 | 1 |
|
|
|
|
| |
|
| 5 |
|
|
|
|
|
|
| Welded Bolts | |
7 |
|
|
|
|
|
|
|
|
| 61 | 41 |
|
|
|
|
| |
|
|
|
|
| 3 |
|
|
|
|
| 63 |
|
|
|
|
| 77 |
7
