2.Insert a Handrail (67) into the Upper Handrail (68) as shown. The lower end of the Handrail should sit on the Base Hood (105) as shown. (Note: It may be necessary to twist the Handrail as you insert it. It may also be neces- sary to loosen the two 1/2” Screws [63] several turns.) Next, tighten two 3/4” Screws (66) into the Handrail. If you loosened the 1/2” Screws, retighten them.
Attach the other Handrail (not shown) to the left side of the Incline Trainer in the same way.
3.Interlock the tabs on the Right Outer Cover (88) with the tabs on the Right Inner Cover (65). Attach the Right Outer Cover with two 3/4” Bolts (60) as shown
4.Remove the knob from the pin. Make sure that the collar and the spring are on the pin. Insert the threaded end of the pin through the hole in the Left Outer Cover (61).
Tighten the knob back onto the pin.
Insert the pin into the hole in the Left Inner Cover (106). Interlock the tabs on the Left Outer Cover (61) with the tabs on the Left Inner Cover. Attach the Left Outer Cover with two 3/4” Bolts (60).
2 |
|
|
|
| 68 |
|
| 63 |
|
| 66 |
|
| 67 |
|
| 105 |
3 |
|
|
|
| 88 |
| 65 |
|
|
| 60 |
4 |
|
|
| 60 | 61 |
|
| |
Knob |
| Spring |
|
| Pin |
|
| Collar |
|
| 106 |
7
