![](/images/new-backgrounds/1134285/13428511x1.webp)
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrench and your own phillips screwdriver
, and
rubber mallet . For help identifying the assembly hardware, see the drawings below. The num- ber in parentheses below each drawing is the key number of the part, from the PART LIST on pages 26 and 27. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been
Plastic Washer | Extension Leg | Star Washer | 1” Tek Screw | |
| Nut | |||
| ||||
|
|
|
| |
Extension Leg Bolt |
| Console Bolt |
1. Make sure that the power cord is unplugged. | 1 | |
| ||
With the help of a second person, carefully tip | Bracket | |
| ||
the treadmill onto its side as shown. Partially fold | 67 | |
the Frame (55) so the treadmill is more stable. | 87 | |
Do not fully fold the treadmill until it is com- | ||
| ||
pletely assembled. |
| |
Insert an Extension Leg (97) into the indicated | 106 | |
bracket on the base of the Uprights (85). Make |
| |
sure that the Extension Leg is turned so the Base | 97 | |
Pad (81) is on the side shown. If necessary, use | ||
| ||
a rubber mallet to align the holes in the | 81 | |
Extension Leg with the holes in the bracket. | ||
85 | ||
| ||
Attach the Extension Leg (97) with two Extension |
| |
Leg Bolts (87), two Star Washers (67), and two |
| |
Extension Leg Nuts (106) as shown. Firmly |
| |
tighten the Extension Bolts. |
| |
With the help of a second person, carefully tip the | 55 | |
treadmill onto its other side. | ||
| ||
| 6 |