5.Remove the knob from the pin. Make sure that the collar and the spring are on the pin.
Press the Latch Insert (77) into the right side of the left Upright (85), and press the Knob Insert (92) into the left side of the left Upright. Use a rubber mallet, if necessary. Next, insert the pin into the Latch Insert, and tighten the knob back onto the pin.
Plug in the power cord as described on page 10, and turn on the power as described on page 12. Note: The treadmill may automatically rise to the maximum incline level and then return to the minimum level.
6.Place the treadmill in the storage position (see HOW TO FOLD AND MOVE THE TREADMILL on page 27).
Hold the cylinder end of the Shock (114) near the bracket in the center of the crossbar on the Frame (55).
See the two small inset drawings. Using your fingernail or the end of a screwdriver, press on the end of the Shock Clip (108) to loosen it from the Shock (114). Next, rotate the Shock Clip and pull it out of the Shock. Be careful to avoid losing the Shock Clip.
Orient the Shock (114) so it is in the position shown. Press the end of the Shock onto the ball on the bracket.
See drawing 6a. Insert the Shock Clip (108) into the two indicated small holes in the end of the Shock (114). Then, rotate the Shock Clip until it clips onto the Shock. Note: Extra Shock Pins are included.
5 |
|
|
Knob | 77 |
|
|
| |
92 | Spring | |
|
| |
|
| Collar |
85 |
| Pin |
6 |
| 108 |
| 114 | |
|
| |
| Cylinder |
|
| Bracket | 108 |
| 55 | |
|
| |
108 |
|
|
6a |
|
|
| 114 |
|
| Bracket | |
Hole |
|
|
108 | Hole |
|
8
