NordicTrack NTL21005.0 user manual PLS2, Make sure that no wires are pinched. See step

5.With the help of a second person, raise the Frame (7) to the storage position and make sure that the latch pin is engaged as described on page 22.

Position the Base Plate (115) on the treadmill as shown. Attach the Base Plate with the three 2" Bolts (114). Note: It may be helpful if a second person tips the treadmill slightly as you tighten the Base Plate Screws.

Carefully lower the Frame (7) to the floor as de- scribed on page 23.

5

7

114

115

6.Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor. For your benefit, familiarize yourself with the TROUBLESHOOTING informa- tion on pages 24 to 25.

If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the re- ceiver included with the chest pulse sensor.

1. Make sure that the power cord is unplugged.		1	88
	Remove the indicated Screws (6) from the
	Console Base (88).
	Important: The Screws (6) may be different
	lengths. Keep track of which Screws were re-
	moved from which holes.		88
			6
2. Peel the paper off the pad on the bottom of the		2
	Receiver (A). Turn the Receiver so the cylin-
	der is on the side shown, and press the		A
	Receiver into the bottom of the Console Frame
	(120) in the indicated location.
			Cylinder
			120
3.	Connect the included Short Jumper Wire (E) to	3	C
	the wire on the Receiver (B). Connect the other
	end of the Short Jumper Wire to the PLS2 jack		PLS2
	on the back of the Console (C). If there is a wire
			Jack
	already plugged into the PLS2 jack, unplug it.
	Note: The other wires included with the receiver
	may be discarded. The Wire Tie can be used to
	tie wires, if needed.
	Make sure that no wires are pinched. See step
	1. Reattach the Console (C) with the Screws.
	Important: If the Screws are not put back into		E
	the same holes from which they were re-
	moved, the Console will be damaged.		B
		8