4.Cut the plastic tie holding the Upright Wire Harness (119) in the right Upright (99). Have a second person hold the Handrails (83) near the Uprights. Connect the Upright Wire Harness to the wires extending from the Console Base (130). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. Then, insert the connectors and the Upright Wire Harness into the hole in the right Upright.
Set the Handrails (83) on the Uprights (99), being careful not to pinch the wires.
5.Insert two 4 1/2” Bolts (104) with Star Washers (106) into the right Upright (99) and the right Handrail (83). Be careful not to pinch the wires. Next, lift the right Handrail slightly and align the Bolts with the holes in the Handrail. Thread the Bolts into the Handrail. Do not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way. Then, tighten all four 4 1/2” Bolts (104). There are no wires on the left side.
6.Attach the Upper Handrail (19) to the Uprights (99) with two 3” Bolts (56) and two Handrail Washers (69) as shown. Firmly tighten the Bolts.
Press the two Upright Endcaps (118) into the Uprights (99) as shown.
4 |
|
|
|
|
| 130 |
|
|
| 119 |
|
|
|
| 99 |
| 83 |
|
|
5 |
|
|
|
|
|
| 99 |
| 83 |
|
|
|
| 106 | 104 |
6 | 19 |
|
|
|
|
| |
| 118 |
| 118 |
|
| 99 |
|
|
| 69 |
|
| 56 | 56 |
|
7.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 29). To protect the floor or carpet from damage, place a mat under the treadmill.
7
