NordicTrack NTL24950 user manual Washers 114. Firmly tighten the four Console Bolts, This step

2. Have a second person hold the console assembly near	2
the Upright (111). Insert the cable and the wire harness
extending from the console assembly through the hole in
the top of the Upright. Attach the console assembly to the
Upright with four Console Bolts (110) and two Star
Washers (114). Firmly tighten the four Console Bolts.
Next, connect the cable and the wire harness extending				108
from the console assembly to the TV Cable (109) and the
Wire Harness (108). The connectors should slide to-
gether easily and snap into place. If they do not, turn				Console
one connector and try again.			109
				Assembly
			114	114
				110
			110
			111	108
3. Note: For clarity, the console assembly is not shown	3	Cutouts
in this step.
				112
Orient the Short Panel (106) so that the indicated cutouts
are at the top. Have a second person hold the Short Panel				139
against the Upright (111), with the top of the Short	140		108
Panel flush with the top of the Upright. Route the TV
Cable (109) down one side of the Short Panel, and route		109
the Wire Harness (108) down the other side of the Short
Panel, as shown.
Next, hold the Long Panel (112) against the opposite side			140	139
of the Upright (111); make sure that the top of the Long
Panel is flush with the top of the Upright and that no		106
wires are pinched. Press the Long Panel and the Short	111
Panel (106) together, and align the three holes in the
Long Panel with the holes in the three Panel Brackets
(140). Attach the Long Panel and the Short Panel with
three Panel Screws (139).				139
Firmly tighten the four Upright Bolts (113).			140
				113

8