Frame Assembly
1.Before beginning assembly, make sure you have read and understood the information on page 5.
Open the parts bags labeled “FRAME ASSEM- BLY” and “PULLEY”.
Attach the Press Frame (101) to the Base Support
(103)with the 3/8” x 3 3/4” Carriage Bolt (119) and a 3/8” Nylon Locknut (118).
Attach a 4” Pulley (113) and a Cable Trap (116) to the Base Support (103) with the 3/8” x 5” Bolt (123) and a 3/8” Nylon Locknut (118).
2.Remove the inner cap and the four hole plugs from the end of the stabilizer.
Secure the Base Support (103) to the stabilizer with two 3/8” x 2 3/4” Bolts (125), four 3/8” Washers (120), and two 3/8” Nylon Locknuts (118).
Press the inner cap into the indicated end of the Base Support (103).
3.Attach the Handles (109) to the Seat Frame (106) with four 1/4” x 1 1/2” Bolts (131) and four 1/4” Nylon Locknuts (128). Note: Be sure that the heads on the 1/4” x 1 1/2” Bolts fit inside the hexagonal holes in the Handles.
Press a 2” Square Inner Cap (112) into the top of the Seat Frame (106). Make sure there are two Seat Frame Bushings (132) into the indicated ends of the Seat Frame.
1 | 118 |
|
|
| |
| 113 |
|
| 116 |
|
| 118 |
|
|
| 101 |
| 103 |
|
| 119 | 123 |
|
| |
2 |
|
|
| Stabilizer |
|
| Inner Cap |
|
| 118 |
|
| 120 |
|
| 103 | Hole Plugs |
|
| |
| 120 | 125 |
Inner Cap |
| |
3 | 112 |
|
|
| |
| 106 |
|
| 128 | 109 |
| 132 |
|
| 128 |
|
109 | 131 | |
| ||
| 131 | 132 |
|
| |
6
