12.Wrap the Cable (133) around a 4” Pulley (113) and attach the Pulley and a Cable Trap (116) to the weld- ed bracket on the stabilizer with a 3/8” x 2” Bolt (121) and a 3/8” Nylon Locknut (118).
IMPORTANT: If you are assembling the leg press accessory at the same time as your weight system, continue with Assembly Option A, below.
If your weight system is already assembled, contin- ue with Assembly Option B, on page 11.
Note: At this point you will begin using parts from both the leg press accessory and your weight sys- tem. Pay attention to key numbers as they will cor- respond to two different part lists.
Assembly Option A
13.Locate the Pulley Bracket (91), one 1/4” Flat Washer (71), and one 1/4” Nylon Locknut (25) that came with your weight system. Attach the end of the Cable (133) to the Pulley Bracket with the Flat Washer and the Nylon Locknut.
14.Install the High Cable (73) to the point indicated as instructed in your weight system manual. Substitute the following steps for those in the manual to complete the installation of the High Cable.
Wrap the High Cable (73) around a 4” Pulley (35) and attach the Pulley and a Cable Trap (44) to the top hole in the Pulley Bracket (91) with a 3/8” x 1 3/4” Bolt (60) and a 3/8” Nylon Locknut (63).
15.Wrap the High Cable (73) around a 4” Pulley (35) in the direction shown and attach the Pulley to the Top Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat Washers (55), two 5/8” x 1/2” Pulley Bushings (42), and a 3/8” Nylon Locknut (63).
12 |
|
|
|
|
|
|
|
| 113 |
| 121 |
|
| 116 |
|
|
|
| Bracket |
|
|
| 133 | 118 |
13 |
|
|
|
|
| 25 |
|
| 91 |
| 71 |
|
|
|
|
|
| 133 | |
14 |
|
|
|
|
| 44 | 35 |
|
|
|
|
|
| |
| 63 |
|
|
|
| 73 |
|
|
|
|
| 91 | 60 |
|
|
|
|
| |
15 |
|
|
|
|
63 | 35 |
| 73 |
|
| 1 |
| ||
|
|
|
| |
55 |
|
|
|
|
| 42 |
|
|
|
|
| 55 |
|
|
|
|
| 54 |
|
9
