4.Slide the Press Frame (102) into the Seat Frame (106).

Press a 2” Square Inner Cap (112) into the indicated end of the Press Frame (102). Press a 2” Square Angled Cap (126) onto the other end of the Press Frame.

Note: Make sure the Support Plate (135 [not shown]) is inside the 2” Square Angled Cap (126).

5.Attach the Seat Frame (106) to the Press Base (101) with four 3/8” x 3” Carriage Bolts (115) and four 3/8” Nylon Locknuts (118).

6.Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the Rear and Forward Press Uprights (104, 105) to the Press Base (101) with the Bolts and two 3/8” Nylon Locknuts (118). Note: the Rear Press Upright has an extra hole halfway down the side.

Press two 2” Square Inner Caps (112) into the Rear and Forward Press Uprights (104, 105).

Do not over tighten the Bolts; the Press Uprights must be able to pivot freely.

7.Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the Press Plates (108) to the Rear and Forward Press Uprights (104, 105) with the Bolts and two 3/8” Jam Nuts (122).

Do not over tighten the Bolts; the Press Uprights must be able to pivot freely.

4

 

 

 

 

129

 

 

 

 

 

106

 

112

 

 

 

 

 

126

 

 

102

 

5

 

 

 

115

106

 

 

 

115

 

 

118

 

 

 

101

118

 

6

 

 

112

 

 

104

 

 

 

 

105

 

101

 

124

 

118

Lubricate

 

 

7

 

 

 

 

 

 

124

 

 

 

Lubricate

 

104

 

 

 

 

 

108

122

108

 

105

7

Page 7
Image 7
NordicTrack NTSA03990 user manual