16.Wrap the High Cable (73) around a 4” Pulley (35) in the direction shown and attach the Pulley inside the Top Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat Washers (55), two 5/8” x 1/2” Pulley Bushings (42), and a 3/8” Nylon Jamnut (63).
17.Thread the 1/2” Plain Nut (68) part way onto the bolt at the end of the High Cable (73).
Place the 1 1/2” Flat Washer (40) on top of the Weight Tube (36) and the 5 7/8” Long Bushing (76).
Tighten the bolt at the end of the High Cable (73) into the threaded hole in the Weight Tube (36).
When all Cables (73, 72 [not shown], 133 [not shown]) are tight, tighten the 1/2” Plain Nut (68) against the
1 1/2”Flat Washer (40).
16 | 42 | 35 |
|
| 42 |
63 |
|
|
55 |
|
|
1 |
| 55 |
| 73 | 54 |
17 |
| 73 |
|
| |
|
| 68 |
|
| 40 |
|
| 76 |
|
| 36 |
Go to the Seat And Plate Assembly section on page 12 and continue with step 18.
10