12.Wrap the Cable (133) under a 4” Pulley (113) and attach the Pulley and a Cable Trap (116) to the weld- ed bracket on the stabilizer with a 3/8” x 2” Bolt (121) and a 3/8” Nylon Locknut (118).
IMPORTANT: If you are assembling the leg press accessory and your weight system at the same time, continue with Assembly Option A, below. If your weight system is already assembled, continue with Assembly Option B, on page 11.
Note: At this point, you will begin using parts from both the leg press accessory and your weight sys- tem. Pay attention to key numbers as they will cor- respond to two different part lists.
Assembly Option A
13.Locate the Pulley Bracket (91), a 1/4” Flat Washer (71), and a 1/4” Nylon Locknut (25) that came with your weight system. Attach the end of the Cable (133) to the Pulley Bracket with the Flat Washer and the Nylon Locknut.
14.Install the High Cable (73) to the stage shown at the right as instructed in your weight system manual. Then, substitute the following steps for those in the manual to complete the installation of the High Cable.
Wrap the High Cable (73) under a 4” Pulley (35) and attach the Pulley and a Cable Trap (44) to the top hole in the Pulley Bracket (91) with a 3/8” x 1 3/4” Bolt (60) and a 3/8” Nylon Jamnut (63).
15.Wrap the High Cable (73) up around a 4” Pulley (35) in the direction shown and attach the Pulley inside the Top Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat Washers (55), two 5/8” x 1/2” Pulley Bushings (42), and a 3/8” Nylon Jamnut (63).
12 |
|
|
|
|
|
|
|
| 113 |
| 121 |
|
| 116 |
|
|
|
| Bracket |
|
|
| 133 | 118 |
13 |
|
|
|
|
| 25 |
|
| 91 |
| 71 |
|
|
|
|
|
| 133 | |
14 |
|
|
|
|
| 44 | 35 |
|
|
|
|
|
| |
| 63 |
|
|
|
| 73 |
|
|
|
|
| 91 | 60 |
|
|
|
|
| |
15 |
|
|
|
|
63 | 35 |
| 73 |
|
| 1 |
| ||
|
|
|
| |
55 |
|
|
|
|
| 42 |
|
|
|
|
| 55 |
|
|
|
|
| 54 |
|
9
