Cable Assembly
8.Open the parts bag labeled “CABLE ASSEMBLY.”
Attach the Cable (133) to the indicated hole in the Press Base (101) with a 3/8” x 3” Bolt (117), two 3/8” Washers (120), a 5/8” x 1/4” Spacer (127), and a 3/8” Nylon Jam Nut (122). Do not over tighten the Nylon
Jam Nut; the Cable must be able to pivot easily.
9.Wrap the Cable (133) up around a 4” Pulley (113) and attach the Pulley and a Cable Trap (116) to the Rear Press Upright (104) with a 3/8” x 3 3/4” Bolt (110), a 3/8” Washer (120), and a 3/8” Nylon Locknut (118).
Make sure the Cable is routed in the direction shown.
10.Wrap the Cable (133) under a 4” Pulley (113) and attach the Pulley and a Cable Trap (116) to the Base Frame (101) with a 3/8” x 3 3/4” Bolt (110), a 3/8” Washer (120), and a 3/8” Nylon Locknut (118).Make sure the Cable is routed in the direction shown.
11.Insert the end of the Cable (133) between the 4” Pulley (113) and the Cable Trap (116) assembled in step one.
8 |
|
|
|
|
|
| 122 |
|
| 120 |
|
|
| 127 | 133 |
|
|
| |
| 120 |
|
|
| 117 |
|
|
|
| 101 |
|
9 |
|
|
|
|
|
| 110 |
|
|
| 113 |
|
|
| 133 |
|
|
| 116 |
| 120 |
|
|
| 118 | 104 |
|
|
|
| |
10 |
|
|
|
| 101 |
| 110 |
|
|
| 113 |
|
| 116 |
|
|
|
| 133 |
118 | 120 |
|
|
|
|
| |
11 |
|
|
|
| 133 |
|
|
| 116 |
|
|
| 113 |
|
|
8
