Nortel Networks 1010, 1050, 1100 manual Connecting the power cord, Caution Risk of equipment damage

26Chapter 1 Hardware overview

Connecting the power cord

You must order the power cord for the VPN Router 1010/1050/1100 separately. The power cord must meet the requirements described in Table 2.

Caution: Risk of equipment damage

Do not modify or use the AC power cord if it is not the exact type that is required for your power outlet.

Table 2 Power cord requirements

Requirement	Description
Current rating	The power cord must be rated for the available AC voltage
	and must have a current rating that is at least 125 percent of
	the gateway’s current rating (1.5 A).
Certification	The power cord must have certification marks from an
	acceptable regional agency.
Cord length and flexibility	The power cord must be less than 4.5 meters (14.7 feet) long.
	It must be a flexible HAR (harmonized) cord or VDE-certified
	cordage to comply with the gateway’s safety certifications.
Power supply connector	The connector that you plug into the AC receptacle on the
	gateway power supply must be an IEC 320, Sheet C5 female.
Wall outlet connector	The power cord must terminate in a male plug with
	appropriate grounding.

Caution: Before you connect the power supply to the gateway, connect the cables to the Ethernet and serial ports. If you have a VPN Router 1100, also connect the cables to the ports on any installed option cards.

To connect the power cord and turn on the power:

1Plug the power cord into the AC receptacle on the external power supply shipped with the VPN Router 1010/1050/1100.

NN46110-313 02.01