Nortel Networks 2330 quick start Configure dynamic registration from SR gateway to active SPS

37

cac

max-calls ethernet0/1 256

10.Configure the CAC exclusion pool that identifies the IP address range of the SIP endpoints that use SSM:

exclude-pool 100.20.47.0 255.255.255.0 exit cac

11.Point the SSM to the SIP Media Gateway IP interface as the default gateway (specifying the non-default port), Port should be same as configured for gateway’s listening port in step 3.:

default-gateway ipv4:100.20.42.80:5070 transport udp exit ssm

exit voip

12.Configure the outbound proxy on the SIP Media Gateway to point to the SSM:

sip-ua

outbound-proxy ipv4:100.20.42.80:5060

13.Configure the primary and secondary SPS for the SIP Media Gateway: (No need to configure secondary sip-server if there is only one SPS used):

sip-server ipv4:100.20.42.77:5060 sip-server ipv4:100.20.42.82:5060 secondary

14.Configure authentication parameters to be used for gateway to SPS calls and registration:

authentication SR 4134 1234

15.Configure keepalive to monitor primary and secondary SPS connectivity:

keepalive target sip-server

keepalive target sip-server secondary

16.Configure dynamic registration from SR gateway to active SPS.

register dynamic exit sip-ua

17.Configure voice ports for FXS phones

(example for 2 FXS phones connected to port 2/1 and 2/2)

voice-port 2/1 signal loop-start station number 74001