Mounting the POTS Splitter Housing
The POTS splitter can be placed:
HOn the outside of the structure near the NID or punchdown block, or
HInside the building.
When mounted outside, the POTS splitter must be installed at or above the height of the NID, and should be a minimum of three feet above ground.
At the front of the housing, align the housing to open from the right with the rubber grommet for cable access facing downward. Place the housing upright as shown. Use a
If mounting to:
POTS Splitter Housing
HCement or cinder block: use a drill and
and 3/16″ masonry drill bit to install the two plastic anchors first. Then, install the two 8±15 x 1″ Type A screws.
H Wood: install only the two 8±15 x 1″ Type A screws and discard the plastic anchors.
3
