DSL Access Wiring
"Procedure
1.Attach new wiring to the T1/R1 connectors that will go to the DSL jack from the punchdown block or NID.
2.Tighten the T1/R1 terminal screws with a
POTS Splitter
Punchdown
Block or NID
Central
Office
POTS/DSL
Local Loop
Demarcation Point
Customer Premises
DSL
RJ11
Jack
Twisted
Pair Wiring
You are now ready to run the specified wiring to the RTU location and install a DSL wall jack. To install an RTU, refer to the HotWire 5446 Remote Termination Unit (RTU) Customer Premises Installation Instructions.
If the RTU is not being installed at this time, reconnect the local loop wiring at the demarcation point.
9
