Preinstallation requirements Standard 1.01
38 CallPilot
The following diagram shows how to remove the side panel. See the instructions for removal below. 1Place the server on its side on your working surface.
2Turn the two thumbscrews on the back of the server counter-clockwise to
loosen them.
Note: The thumbscrews are not removable.
Note: If a removable screw is present, remove it. This screw secures the
cover to the server during shipping.
3Place your fingertips in the depression on the side cover, and then as
you apply pressure, pull the cover approximately 2.5 cm (1 in.) away from
the front of the server until it stops.
1
2
G101761
3