November 2005 Installing the server and connecting the peripheral devices
Part 2: 703t Server Hardware Installation 55
To connect the mouse, keyboard, and monitor to the server
1Place the monitor, keyboard, and mouse in the same location as the
server.
2Plug the keyboard and mouse into the appropriate PS/2 connectors on
the chassis rear panel. See the diagram on page 54.
3Plug in the monitor connector. Tighten the screws on the connector.
4Connect the power cord to the monitor, and plug the other end into a wall
receptacle or power bar.
5Turn on the monitor.
To connect the modem to the server
1Ensure that the modem’s AC power cord is not plugged in.
2Connect the large 25-pin male connector to the back of the modem.
Tighten the connector screws.
3Connect the 9-pin female connector to COM1 port at the rear of the
server. Tighten the connector screws.
4Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
5Connect the other end of the telephone cable to the RJ-11 jack in the
wall.
6Connect the power cord to the modem, and plug the other end into a wall
receptacle or power bar.
7Turn on the modem.
What’s next?

Continue with “Connecting the server to the ELAN” on page 57.