Preinstallation requirements Standard 1.01
40 CallPilot
Inspecting the server interior
Introduction

Before you install the server, you should perform a visual inspection for

loose components, foreign matter, or shipping damage inside the server.

To inspect the server interior

1Ensure that all the cards are fully seated on the baseboard.
2Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
3Review the slot locations (see “Rear panel diagram” on page 16).
4Do one of the following:
.
CAUTION
Risk of equipment damage

When working with interior components, use an ESD wrist

strap to protect static-sensitive components.

IF THEN
you observe
any damage
contact your Nortel Networks technical
support representative.
components have
become loose
secure them. Then replace the server
cover and proceed with the hardware
installation.
Refer to the procedures in CallPilot
Installation and Configuration Part5:
703t Server Maintenance and
Diagnostics (555-7101-227).