Technical Configuration Guide for SNMP | v2.0 | December 2006 |
•
e)Enable access strict enable
•ERS-8610:5# config sys access-policy policy 2 access-strict true
f)Enable telnet and SNMPv3 service:
•ERS-8610:5# config sys access-policy policy 2 service telnet enable
•ERS-8610:5# config sys access-policy policy 2 service snmpv3 enable
g)Enable policy 2:
•ERS-8610:5# config sys access-policy policy 2 enable
h)After the policy has been created, enter the following command to view policy 2:
•
AccessPolicyEnable: on
Id: 2
Name: policy2
PolicyEnable: true
Mode: allow
Service: telnetsnmpv3
Precedence: 10
NetAddr: 0.0.0.0
NetMask: 0.0.0.0
TrustedHostAddr: 0.0.0.0
TrustedHostUserName: none
AccessLevel: readWriteAll
AccessStrict: true
Usage: 3777
•ERS-8610:5# show sys access-policy snmp-group-info snmpv3-groups :
Policy | 1 | : |
| |
|
| Group | Name | |
Policy | 2 | : |
| |
|
| Group | Name | |
|
| group_example |
| usm |
3.3.2 SNMPv1/2 Group Access Policy: Configuration Example
As release 3.7 and 4.1 is based on the SNMPv3, you must add the SNMPv3 group name and model for both SNMPv1 and SNMPv2 when setting up an access policy. To view the SNMPv3 group name and model, please use the following as shown below. Note that the items high- lighted in red need to be added when setting up the access policy.
•ERS8610-B:5# show snmp-v3 group-access
=========================================================================
VACM Group Access Configuration
=========================================================================
______________________________________________________________________________________________________
NORTEL | External Distribution | 11 |