Technical Configuration Guide for SNMP | v2.0 | December 2006 |
3.3.5 Creating or deleting trap receivers with Software release 3.7 or 4.1
With software release 3.7 or 4.1, you create trap receivers by creating
By default, the ERS8600 has a default trap notification of “trapTag”. You can use this default notification when setting up the SNMP trap target address or if you wish, you can create a new trap notification using the following command:
•ERS-8606:5# config snmp-v3 notify ?
Current Context:
create <Notify Name> [tag <value>] [type <value>] delete <Notify Name>
info
tag <Notify Name>
For example, to create a new trap notification named “Trap2” with a tag value of “Trap2”, please enter the following command
•ERS-8606:5# config snmp-v3 notify create Trap2 tag trapTag2 type trap
You can view the notification table by using the following command:
•ERS-8606:5# show snmp-v3 notify info
===========================================================================
Notify Configuration
===========================================================================
Notify NameTagType
Inform | informTag | inform |
Trap | trapTag | trap |
Trap2 | trapTag2 | trap |
The SNMP target address is configured using the following command:
•ERS-8606:5# config snmp-v3 target-addr ?
create <Target Name> <Ip addr:port> <Target parm> [timeout <value>] [retry <value>] [taglist <value>] [mask <value>] [mms <value>]
delete <Target Name> info
address <Target Name>
______________________________________________________________________________________________________
NORTEL | External Distribution | 17 |