Chapter 3 Installing the expansion module 23

Mounting the expansion module and phone on a wall

You can wall-mount an IP Phone with an expansion module. You need the mounting template and the mounting bracket that came with the expansion module. You must attach the expansion module to your IP Phone before you mount them on the wall.

Complete this procedure if you plan to mount the base station on a wall or ceiling. Skip this procedure if you plan to place the base station on a flat surface.

1Place the mounting template against the wall where you want to install the IP Phone and expansion module.

The template provides guidelines for mounting one IP Phone with up to two or more expansion modules.

2Use the mounting template to position the IP Phone and expansion module.

3Mark the screw positions.

4Use the screws to attach the mounting brackets to a wall.

5Align the notches on the back of the IP Phone and expansion module with the mounting bracket on the wall.

6Push the IP Phone and expansion module against the brackets until they are securely connected.

Adjusting the tilt base

The expansion module stand provides a continuous tilt adjustment so the tilt angle matches the IP Phone stand angle while accommodating variations in the desk surface. Use the clamp mechanism to unlock and lock the foot stand angle.

Caution: Risk of damaging equipment

Do not over-tighten the foot stand wheel on the expansion module. This can damage the wheel and the stand.

1Turn the wheel on the back right-hand side of the expansion module to loosen the foot stand hinge.

2Adjust the angle of the IP Phone using the tilt lever.

3When the IP Phone is set to a preferred angle, turn the wheel on the back of the expansion module to tighten the foot stand hinge and lock the stand at the same angle as the attached IP Phone.

Expansion Module 1100 Series User Guide

Page 23
Image 23
Nortel Networks IP Phone 1100 manual Mounting the expansion module and phone on a wall, Adjusting the tilt base