Nortel Networks V.34 manual Installing and Operating the Passport

V.34 Modem Adapter Module Supplement

Completing Software Configuration

Once you have successfully installed the V.34 Modem adapter module, complete the following software configuration tasks using instructions found in your BayRS documentation:

Configuration Task	Location of Instructions
Modify the configuration file to add the V.34	Any of the following:
Modem adapter module and enable default	• Configuring and Managing Routers with
software services.	Site Manager
	• Using the Bay Command Console
When using Bay Command Console (BCC)	(BCC)
commands on a Passport 2430, note that
the name for the V.34 Modem adapter
module is arnv34.
Connect the Passport 2430 to the network.	One of the following:
	• Installing and Operating the Passport
	2430 Multiservice Access Switch
	• Configuring Remote Access for AN and
	Passport ARN Routers
Configure V.34 modem services.	Configuring Dial Services

For the latest information, be sure to review the release notes and documentation change notice for your version of BayRS software.

Interpreting LEDs

The V.34 modem adapter has four LEDs, located to the right of the connector (Figure 3-2).

Telco

TXRLSD

V.34 Modem RX DTR

Complies with FCC Rules Part 68 Reg. Number 4P8USA-30661-MD-E Ringer Equivalence 0.6B

ARN0107A

Figure 3-2. V.34 Modem Adapter Module LEDs

3-2 303127-D Rev 00