North Star M165938N Connecting Loads, Using as a Portable Power Source, Operation cont’d

Operation (cont’d)

5. Connecting Loads

You will want to be careful when connecting loads so as not to overload the generator, especially if you are powering devices with motors that require a higher starting power load.

Instructions are provided below for connecting loads when you are using the generator:

oAs a portable power source

oConnected to a building as a back-up power source

WARNING:

Do not overload generator. Make sure that combined starting and running loads do not exceed rated capacity of generator. Overloading the generator can cause damage to the generator and attached electrical devices, and may result in fire.

Using as a

Portable Power

Source

Using as a Back-up Power Source for a Building

Connect electrical loads one at a time according to the following instructions:

1.Allow engine to reach operating speed by allowing it to warm up for approximately 5 minutes before connecting electrical devices.

2.After engine is warmed up, begin by connecting the items that require the highest wattage first. The recommended sequence is as follows:

a.Connect items with motors such as refrigerators, freezers, air conditioners, or small hand tools, one at a time. Let each motor stabilize before connecting the next device.

b.Connect any lights you are planning on powering.

c.Connect voltage sensitive equipment such as electronics via surge protectors. Plug devices such as TV’s, computers, and microwaves into a UL listed voltage surge protector, then plug the surge protector into the generator.

Each transfer switch installation will be unique.

Proper instructions for how to safely bring the generator online with the building’s electrical system should be provided by the installing electrician, who should also provide personal instruction to the owner/operator.

Failure to follow the proper procedure as provided by the electrician could expose persons to the hazards noted above.

33