NorthStar Navigation NS3300 manual Menus, Setup System

6 Menus

Many of the NS3300 Pilot features and functions are operated through menus.

•To scroll through menu items, scroll through items in a list or change data use the Control Dial. Clockwise scrolls across/down or increments data.

•To select a menu item press .

•To go back to the previous menu press .

•To accept changes press .

•To discard changes press .

Occasionally items in the NS3300 Pilotmenus utilize checkboxes.

•If the box is ‘checked’ (contains a check or tick), then that function is selected (enabled) or ON.

•If the box is ‘un-checked’ (does not contain a check or tick), then that function de-selected (disabled) or OFF.

•To select or de-select a checkbox, highlight the menu

item using the control dial and press . The change will happen immediately.

The main menu for configuring the NS3300 Pilot is the

Setup menu. Press until the Setup menu is displayed (normally twice).

The Setup menu and options are summarized in this chapter. The factory default settings are shown where applicable. Each Setup menu option is explained in the following sections.

6-1 Setup > System

Tip: In case you can’t read the current language, the language setting is the first item in the system menu.

Language

Select the language for the display. The options are: English, Italian, French, German, Spanish, Dutch, Swedish, Portuguese, Finnish and Greek.

Backlight

The backlight pop-up is displayed (see also section 3-4).

The bar setting represents the current level of backlighting.

Night Mode –Allows low contrast Night mode.

Auto – allows night mode to be selected in backlight pop-up

On – night mode is active all the time Off – night mode tis not available

Key beep

Enables or disables an audible beep when a key is pressed or Control Dial is rotated.

Auto power off

Select to have the autopilot power off automatically every time the boat’s ignition is switched off. This applies only if the display unit is wired for Auto Power (see installation manual).

About

Displays information about the unit.

Factory Reset Resets all settings to the factory default settings. A warning box asks: Are you sure? Select Yes

and press to confirm, or No or to cancel.

Main control unit – Resets the MCU’s settings Head unit – Resets just this head unit’s settings

Both – Resets the MCU’s settings and this unit’s settings

26 Northstar NS3300 Pilot