CDN-32SE
CONNECTIONS
Typical connection with a mixer is illustrated right.
1.Connect the output connection cords from the CD Player to the line inputs of your mixer.
2.Connect the remote control connection cable from the Unit 1 connector on the main unit to the Unit 1 connector on the remote control unit. Repeat for Unit 2.
3.The output connection cords and the remote control connection cables are supplied with the main unit. Be sure to use the remote control connection cables which have been supplied. Use of another cable type might cause damage.
4.Connect Fader start cables by attaching both side of your CD player to a similarly equipped DJ mixer, as in the top drawing.
DIGITAL OUTPUTS: This CD player is specially equipped with digital outputs. The format is type 2, form 1, also known as S/PDIF (Sony/Phillips Digital Interface Format). In order to use the digital output you must activate the rear panel switch. When the digital output is active the variable pitch slider and pitch bend buttons or pitch wheel will not work.
Note: If digital information was allowed to change in pitch, other devices will not read the digital output properly.
MOUNTING YOUR CD PLAYER
•Mount the units in your console or rack with 19” EIA rails
•The transport should be mounted not to exceed an angle of 15 degrees.
•Your CD player can be affected by excess vibration so mount the units in a secure environment if possible.
©2001 Numark Industries | - The Leader in DJ Technology | http://www.numark.com |
- 7 - |
