MPCD33
FADER START
Fader Start is achievable by attaching your CD player to a similarly equipped DJ mixer and setting the rear panel selection switch to “mixer” mode.
1.Connect cables between the CD player and your DJ mixer.
2.Press the button or switch on your mixer into fader start mode to activate the fader start capability.
3.Typically if you move the crossfader toward the active channel, the attached CD player will activate. When it is moved away the unit will cue or pause depending upon CD player setting.
To select start/stop mode hold the time button for 3 seconds.
If the display shows then the CD will pause when the crossfader is moved away.
If the display shows then the CD will CUE when the crossfader is moved away.
REMOTE SWITCH START
Remote switch start is achievable by attaching your CD player to a switch like a foot switch found in most music shops. Foot switch connector plugs are often ¼” and an adapter to 1/8” will be needed for connection.
1.Connect the remote switch to your CD player.
2.Select the type of foot switch you will use. There are two types of footswitches that will work with this connector. The first is a typical,
3.Typically if you press the switch once, the attached CD player will activate. When it is pressed again the unit will cue or pause depending upon CD player setting.
Note: You can also use a momentary switch in the
BEFORE SWITCHING OFF THE POWER:
When you have finished using the CD player, be sure that the disc tray is closed with the “OPEN/CLOSE” button before switching off the power.
DO NOT switch off the power when |
| Switch off the power after the |
the disc holder is open. |
| disc holder has been closed |
|
| with the “OPEN/CLOSE” button |
| - The Leader in DJ Technology | |
©2002 Numark Industries | - 14 - | http://www.numark.com |