Numark Industries PRO TT-1 owner manual Rear Panel Diagram, The Leader in DJ Technology

PRO TT-1

REAR PANEL DIAGRAM...

41 42 43

40

45 44

47

46

40.Removable Lid - Protects the turntable from dirt and dust.

41.Hinge Assembly - Holds the lid and turntable together. Attach now by sliding the bottom tabs of the Hinge Assembly into the Hinge Holders (10).

42.Platter Speed Output - This output is to be used with external devices the require platter speed information.

43.Remote Start/Stop - This is used with external control devices.

Tech note: This circuit is a normally open, use a momentary switch and a 1/4” mono plug to change play states of the unit.

44.Adjustable Feet - Turn feet to level the platter surface.

45.Phono Output - Plug these into your mixer or preamplifiers’ turntable input.

46.Ground Cable - Attach to the ground screw on your mixer or preamplifier to prevent turntable hum.

47.Power Cord - Plug this into an appropriate power outlet after checking your power setting switch (18) under the platter.

Note: Please refer to CAUTION on page 2 concern proper use of power

Your assembly should now be complete. Place your turntable on a vibration free level surface and attach to your mixer or preamplifier. If you are using the turntable for slip cueing or mixing music you will want to use the slipmat and not the rubber mat.

- The Leader in DJ Technology

©1999 Industries 9 http://www.numark.com