PRO
8.45 Adapter - Place on Center Spindle (7) for playing 7” records with large center holes.
9.Forward/Reverse Buttons - These determine the direction the platter will spin.
10.Lid Hinge Holder - Place the bottom tabs of your lid hinges in here after you finish assembly.
11.Extra Stylus Holder - Place extra headshells here.
12.Tone Arm Assemble - Explained in tonearm section
13.Pitch Adjust - use this the change the speed of the platter when quartz lock is inactive. You can adjust the revolutions by ±10%.
14. Quartz Lock
On - will hold the revolution speed at exactly the specified speed (3)
Off - will allow use of the Pitch Adjust (13)
15.LCD Display - Explained in Display Section
16.Target Light - Press the button to the right and a light will pop up directed at the stylus position.
17.Voltage Selector - with unit unplugged set the desired
voltage for your location using a screw driver.
115V
230V
TONE ARM ASSEMBLY
30
29
20. Headshell - Attach the cartridge here.
When installing a cartridge, refer to the installation instructions supplied by the manufacturer of that cartridge. During installation, attach the stylus protector to guard the stylus tip from damage.
25
24
28
27
26
Attach wires as follows:
White (L+)Left channel+
Blue
Red (R+)Right channel+
Green
21.Headshell Locking Nut - Attach headshell by inserting into the front end of the tonearm, then turn the locking nut clockwise with the head shell firmly held horizontally.
23
22
21
20
22.
23.Tone Arm Clamp and Rest - Use this rest the tone arm and clamp it in position during transportation.
24.Tone Arm Lift - This elevates the tone arm above the record surface
25.Tone Arm Lift Adjust Screw - Controls the amount of lift
26.Tone Arm Lever - Controls the up and down action of the Tone Arm Lift
- The Leader in DJ Technology
©1999 | Industries | 7 | http://www.numark.com |