PREPARING THE RECEIVER
REMOVING THE RECEIVER COVER | TROUBLESHOOTING GUIDE |
Refer to Figure 4.
1.Press the center of the battery cover, and slide cover toward bottom of receiver.
2.Set battery cover aside.
RECEIVER SECURITY CODING
Refer to Figure 5.
Changing the Security Code is not necessary unless you have changed the security code in the Transmitter.
Both the Transmitter and Receiver codes must match.
1.Remove the same jumpers in
the Receiver as in the Transmitter.
PRESS AND SLIDE BATTERY COVER TOWARD BOTTOM OF RECEIVER
FIGURE 4
|
|
|
|
|
|
| PROBLEM | SOLUTION |
|
| 1. | Chime does not sound. | Check batteries and polarity. |
|
|
|
| Make sure receiver or transmitter |
|
|
|
| is not located on metal surface. |
|
|
|
| Check receiver and transmitter security |
|
|
|
| code. These codes must match. |
|
|
|
|
|
|
| 2. | Chime changes tone. | Check batteries in receiver. |
|
|
|
|
|
|
| 3. | Chime looses volume. | Check batteries in receiver. |
|
|
|
|
|
|
| 4. | Chime is activated by another | Change the security code in the transmitter |
|
|
| wireless device. | and receiver. These codes must match. |
|
|
|
|
|
|
|
|
|
|
|
INSTALLING BATTERIES IN RECEIVER
Refer to Figure 5. Refer to figure 5 for
placement and polarity of batteries. The NuTone Wireless Chime Receiver requires three AA size alkaline batteries.
ATTACHING THE BATTERY COVER
Position battery cover flush to back of Receiver, and slide cover up until it snaps in place.
| SECURITY CODE | ||||
|
| SETTING |
| ||
| 6 | 5 | 4 3 | 2 | 1 |
– | + |
|
|
|
|
+ | – |
|
|
|
|
– | + |
|
|
|
|
| FIGURE 5 | ||||
MOUNTING OF RECEIVER
Refer to Figure 6. Receiver may be used
as a portable receiver or may be wall mounted. Use the following procedure when mounting the Receiver to the wall.
1. Select the desired mounting location. This location should be at least 1 foot away from metal objects and within 100 feet of the chime transmitter.
2. Drill one 3⁄16” hole at the desired mounting height.
3.Insert the plastic anchor into the 3⁄16” hole.
4.Drive the screw into the plastic anchor until the head
of the screw extends approximately 1⁄8” from the mounting surface.
5.Place the keyhole slot in the Receiver base over the screw head. Slide the Receiver down to secure it.
6.Level the chime Receiver on the mounting surface.
ON/OFF SWITCH AND VOLUME CONTROL
1.Slide the switch up one step to turn on the Receiver in the low volume position.
2.Slide the switch to the top position to turn on the Receiver in the high volume position.
NOTE: Receiver battery life can be extended by operating the volume in the low position.
