Nuvo NV-A4DS-UK II. Speaker Wire Termination, III. Allport Termination and Installation

II. Speaker Wire Termination

It is important to keep the proper orientation of positive and negative signal for each speaker connection. Typically, two-conductor speaker wire uses red to denote positive and black to denote negative. Some types of wire indicate positive with a dark line

Fig. 2

running through the insulation. Four-conductor wire can also be used. This has four separate wires in one outer jacket, making it possible to run a single speaker wire to a zone for its pair of speakers. This type of wire typically uses red and black for one speaker and white as positive and green as negative for the second speaker.

Note: The Simplese System is designed to handle one pair of 8-ohm speakers per zone. Using more than one pair of speakers per zone could cause damage to the amplifier output.

III. Allport Termination and Installation

Both the speaker wire and CAT5 cables for each zone terminate into the back side of the Allport. The order of CAT5 plug-ins is irrelevant to the operation of the system, but it is recommended that you label the individual CAT5 cables for future reference. Follow the zone and polarity labeling for the speaker wire termination, fig. 2.

The final connection from the Allport is made with the Allport cable supplied with the Simplese System, fig. 3.

Fig. 3

STATUSLINKSimplese

ON=+12V

D

FOUR-SOURCE FOUR-ZONE

INTE RTEK

CM

CONFORMS TO

UL STD.6500

SPEAKER AND DATA SIGNALS

100~240V 50~60Hz 85W

CERTIFIED TO

C US CAN/CSA STD.E60065

MUTE =0V

NuVo Technologies Cincinnati Ohio USA

RS232

3033118

TERTE

N K

SYSTEM ALL PORT CONNECTION

9