Lighting
1.Turn Gas control knob to “Off” position.
2.Push in and rotate the Control Knob to“Pilot”position. Depress igniter button.
3.Once burner is lit, hold Control Knob in for at least 30 seconds and release.
4.If burner does not stay lit, turn to“Off” position and wait 5 minutes and repeat 2 and 3.
5.Once burner is lit, rotate Knob to desired heating level (LO: low ; HI: high).
If you experience any ignition problem, turn off the heater and gas supply, and consult “Troubleshooting” on page 12.
Caution
Avoid inhaling fumes emitted from the heater's first use. Smoke and odor from the burning of oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT produce thick black smoke.
Note: The burner may be noisy when initially turned on. To eliminate excessive noise from the burner, turn the Control Knob to the LOW position. Then, turn the knob to the level of heat desired.
When heater is ON:
Emitter screen will become bright red due to intense heat. The color is more visible at night.
Burner will display tongues of blue flame. These flames should not be yellow or produce thick black smoke, indicating an obstruction of airflow through the burners.
If yellow flame is detected, turn off heater and gas supply and consult “Troubleshooting”.
Re-lighting
Note: For your safety, Control Knob cannot be turned “Pilot” without first depressing Control Knob in “Off” position and then rotating to “Pilot”.
1.Turn Gas Control Knob to “Off”.
2.Wait 5 minutes to let gas dissipate before attempting to relight burner.
3.Repeat the “Lighting” Steps 2 and 3.
1.Rotate Gas Control Knob to “Off” position. Normally, burner will make a slight popping sound when extinguished.
2.Remove Door Plate.
3.Unscrew gas line from regulator.
4.Close Door Plate. Note: After use, some discoloration of the emitter screen is normal.
10
