Harman Stove Company 828i manual Introduction

4

Introduction

The Harman Clarity 828I Vented Gas Fireplace Insert is a listed gas-fired vented room heater tested by Intertek Testing Services/Warnock Hersey to ANSI standard Z21.88-2002, CSA2.33- M02, and CAN/CGA-2.17-M91.

The installation of the Clarity Fireplace Insert must conform with local codes, or in the absence

oflocal codes, with National Fuel Gas Code, ANSI Z223.1 — latest edition (NFPA 54) and CAN 1 B1-

149.1 and .2 Gas Appliance Installation Code.

Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les Codes d'installation CAN/CGA-B149.

The Clarity Fireplace Insert is not for use in mobile homes.

CAUTION: This appliance must be vented to the outside.

INSTALLATION ANDREPAIR OF THE CLAR- ITY FIREPLACE INSERT SHOULD BE DONE BY A QUALIFIED SERVICE PERSON. THE APPLI- ANCE SHOULD BE INSPECTED BEFORE USE AND AT LEAST ANNUALLY BY A QUALIFIED SERVICE PERSON. MORE FREQUENT CLEAN- ING MAY BE REQUIRED DUE TO EXCESSIVE LINT FROM CARPETING, BEDDING MATE- RIAL, ETC. IT IS IMPERATIVE THAT CONTROL COMPARTMENTS, BURNERS, AND CIRCU- LATING AIR PASSAGEWAYS OF THE APPLI- ANCE BE KEPT CLEAN. ANY SAFETY SCREEN OR GUARD REMOVED FOR SERVICING AN APPLIANCE MUST BE REPLACED PRIOR TO OPERATING THE APPLIANCE.

S'ASSURER QUE LE BRÛLEUR ET LE COMPARTIMENT DES COMMANDES SONT PROPRES. VOIR LES I NSTRUCTI ONS D'INSTALLATION ET D'UTILISATION QUI ACCOMPAGNENT L'APPAREIL.

When operating your Harman Clarity Fireplace Insert, respect basic safety standards.

Read these instructions carefully before you at- tempt to operate the heater. Failure to do so may result in damage to property or personal injury and may void the product warranty.

Consult with your local building code agency and insurance representative before you begin your installation to ensure compliance with local codes, including the need for permits and follow- up inspections.

Observing required clearances to combustible materials, proper connection to an approved vent- ing system, and the accessibility of the gas and electrical supply must all be considered when planning the installation of an Clarity Fireplace Insert.

Adequate clearances around air openings to the combustion chamber and provisions for adequate combustion and ventilation air must be provided.

Install the Clarity Fireplace Insert only in a listed solid-fuel burning factory-built fireplace or a ma- sonry solid-fuel burning fireplace. The Fireplace Insert and vent should be enclosed when installed in, or when passing through, a living area where children may come in contact with it.