Flame Adjustment Levers
11
Pilot Flames as Seen
Through Hole in Left End
of Log
Use a glove to avoid contact if hot. For best results when
MONITORING THE GAS FLAME
Periodically, the flames of the Clarity Fireplace Insert should be checked while it is in operation. The flames should be
If you find the flames to be other than that described here, do not operate the heater. Consult a qualified service person or your Harman dealer for advice.
Operation
HOW TO LIGHT THE FIRE
1.STOP! Read the safety information on the lighting instructions label on the stove.
2.If using the optional thermostat, set thermo- stat to the lowest setting.
3.Turn off electric power to the appliance.
4.Turn the
5.Push in the gas control knob slightly and turn it clockwise to "OFF."
NOTE: The knob cannot be turned from "PILOT" to "OFF" unless it is pushed in slightly. Do not force it.
6.Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information on the
7.Set the
8.Press in the gas control knob slightly and turn counterclockwise to "PILOT."
9.Find the pilot by looking through the round opening on the left end of the center log.
10.Push the control knob fully down and hold. Immediately push the red piezo ignitor button to light the pilot. It is normal to have to push the red button several times before the pilot ignites. Con- tinue to hold the control knob in for about one (1) minute after the pilot is lit. Release the knob and it
will pop back up. Pilot should remain lit. If it goes
out, repeat steps 5 through 9.
•If the knob does not pop up when released, stop and immediately call your service technician
or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.
11.Turn the gas control knob counterclock- wise to "ON."