Harman Stove Company 828i manual Cleaning The Glass, Cleaning The Log Set And Firebox

13

confirm that there is no blockage and that the system is in good repair. Directions for conducting a flue spillage test may be found on page 6. The vent manufacturer's instructions may provide specific suggestions or details on vent inspection. Any sections that are taken apart for the inspection must be reassembled and sealed as required.

CLEANING THE GLASS

The glass may be cleaned with ordinary house- hold glass cleaner and a soft cloth or paper towel.

WARNING: Never clean the glass when it is hot. Do not use abrasive cleaners on the glass.

CLEANING THE LOG SET AND FIREBOX

During the annual inspection and maintenance

CAUTION: If the door is opened or re- moved for servicing, it must be replaced and securely closed before operating the appli- ance. The glass must be securely fixed in the door when operating the appliance.

appointment, the service person should clean dust, lint, and any light accumulation from the logs and the firebox area. An extra-soft brush should be used on the logs as they are extremely fragile; a vacuum cleaner may be used on the firebox. If at any time the logs cannot be removed or installed without forcing, the cause must be found. The logs must never be forced. Follow this sequence:

1.Remove the side trim panels according to the directions on page 12.

2.Remove the glass door according to the direc- tions on page 12.

3.Remove, clean, and re-install the log set, observ- ing the directions on log handling and placement found on pages 7 and 8.

CONVECTION BLOWER SERVICE ACCESS

The blower is located behind a panel that can be accessed by first removing the fuel module. See page 15 for instructions. Remove the two fasteners securing the panel and pull the panel forward. The blower will come out with the panel. Disconnect the blower electrical connector to completely remove the blower from the unit.